Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Refer to Brake Fluid Irritant Warning .

CAUTION: Refer to Brake Fluid Effects on Paint and Electrical Components Caution .

Fig 1: Identifying Master Cylinder Reservoir Bolts

Courtesy of GENERAL MOTORS CORP.

Using a suitable tool, remove the brake fluid from the brake master cylinder reservoir.
Discard the brake fluid into an approved container.
Disconnect the brake fluid level indicator switch electrical connector.
Remove the master cylinder reservoir bolts (1).

Fig 2: View Of Master Cylinder Reservoir

Courtesy of GENERAL MOTORS CORP.

Carefully lift the master cylinder reservoir (1) straight upward and remove the reservoir from the master cylinder.

Fig 3: View Of Master Cylinder Reservoir Seals

Courtesy of GENERAL MOTORS CORP.

Remove the master cylinder reservoir seals (1).