Brake Pedal Assembly Replacement

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Brake Pedal Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Apply the park brake.
1	Brake Booster Pushrod Retainer Bolt (if equipped) CAUTION: Refer to Fastener Caution . Tighten: 10 N.m (89 lb in)
2	Brake Booster Pushrod Retainer Procedure: After installing the retainer to the pushrod pin on the brake pedal, rotate the retainer 360 degrees to ensure it is seated properly before tightening the retainer bolt.
3	Stoplamp Switch
4	Brake Booster Pushrod Procedure: For reassembly, apply a thin coat of high temperature grease GM P/N 12345994 (Canadian P/N 10953501) to the pushrod pin on the brake pedal.
5	Brake Pedal Pivot Nut Procedure: Hold the brake pedal pivot bolt stationary and tighten the brake pedal pivot nut. Tighten: 35 N.m (26 lb ft)
6	Brake Pedal Pivot Bolt
7	Brake Pedal Procedure If installing a new brake pedal pivot bushing, ensure the conical flange end of the bushing is on the inboard side of the pedal. For installation, apply high temperature grease GM P/N 12345994 (Canadian P/N 10953501) to the ID of the brake pedal pivot bushing.