LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1576 (Hydraulic Brake System) >> Repair Instructions >> Brake Master Cylinder Primary Piston Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The ignition must be in the OFF position, without pausing at ACCESSORY, and without applying the brake pedal to ensure the brake modulator and high pressure accumulator (HPA) pressure relief occurs. This process will take approximately 1 to 3 minutes.
  1. Turn the ignition to OFF, without pausing at ACCESSORY, and without applying the brake pedal.

    Remove the ignition key.

  2. Wait approximately 1 to 3 minutes until the brake modulator and HPA pressure relief is complete.
  3. Disconnect the brake master cylinder (BMC) primary piston position sensor electrical connector.
    4. Fig 1: Primary Piston Position Sensor Screws & Primary Piston Position Sensor
    GM1892243Courtesy of GENERAL MOTORS CORP.
  4. Remove the 2 BMC primary piston position sensor screws (1).
  5. Remove the primary piston position sensor (2).

    Tilt the rear of the position sensor downward and remove the sensor.

scientia non olet · About LEMON Manuals