Installation Procedure
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the BMC primary piston position sensor (2).
- Install the 2 BMC primary piston position sensor screws (1) and tighten to 10 N.m (89 lb in).
- Connect the primary piston position sensor electrical connector.
- Inspect the battery state of charge. Refer to Battery Inspection/Test .
- If necessary, connect a battery charger to the 12V battery. Refer to Battery Charging
- Install a scan tool to the vehicle.
- Turn the ignition ON with the engine OFF.
- Using the scan tool, perform the following steps:
- Select Diagnostics
- Select the appropriate vehicle information
- Select Chassis
- Select Electronic Brake Control Module (EBCM)
- Select Module Setup
- Select BMC Primary Piston Position Relearn and follow the instructions on the scan tool
CAUTION:
Refer to Fastener Caution
.
NOTE:
The ignition switch must remain in the ON position with the engine OFF during this procedure.