Brake Fluid Level Indicator Switch Replacement (Two-mode Hybrid)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Brake Fluid Level Indicator Switch (Two-Mode Hybrid)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Place the ignition switch in the OFF position. Disconnect the brake fluid level sensor electrical connector.
1	Brake Fluid Level Sensor Tip: Compress the brake fluid level sensor locking tabs on the opposite side of the master cylinder reservoir to remove.

Callout

Component Name

Preliminary Procedures

Place the ignition switch in the OFF position.
Disconnect the brake fluid level sensor electrical connector.

Brake Fluid Level Sensor
Tip: Compress the brake fluid level sensor locking tabs on the opposite side of the master cylinder reservoir to remove.