LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1572 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Tyco/AMP Connectors (Sensor) >> Terminal Removal Procedure

Terminal Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the connector from the component.
    2. Fig 1: Inserting Special Tool Into Lower Right Face Cavity
    GM1454796Courtesy of GENERAL MOTORS CORP.
  2. Insert the J 38125-11A tool into the cavity on the lower right hand face of the connector until the terminal release tang access panel slides over.
    3. Fig 2: Pushing Wire Side Of Terminal Toward Connector
    GM1454799Courtesy of GENERAL MOTORS CORP.
  3. Ensure that the terminal release tang access panel is in the correct location to access the terminals.
  4. Push the wire side of the terminal that is being removed toward the connector and hold it in position.
    5. Fig 3: Inserting Tool Into Terminal Release Tang Access Slot (Sensor)
    GM1454801Courtesy of GENERAL MOTORS CORP.
  5. Insert the J 38125-11A into the terminal release tang access slot located behind the access panel of the connector and press down on the terminal while carefully pulling the terminal out of the connector. Always remember never use force when pulling a terminal out of a connector. If the terminal is difficult to remove, repeat the entire procedure.
scientia non olet · About LEMON Manuals