LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1572 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Testing for Continuity >> With a Digital Multimeter (DMM)

With a Digital Multimeter (DMM)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the DMM to the Ω position.
  2. Disconnect the power feed (i.e. fuse, control module) from the suspect circuit.
  3. Disconnect the load.
  4. Select the MIN MAX function on the DMM.
  5. Connect one lead of the DMM to one end of the circuit to be tested.
  6. Connect the other lead of the DMM to the other end of the circuit.
  7. If the DMM displays low or no resistance, the circuit has good continuity.
scientia non olet · About LEMON Manuals