LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1572 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Power Mode Mismatch >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Ignition Switch 

  1. Ignition OFF, disconnect the harness connector at the ignition switch.
  2. Verify the resistance between the terminals listed below match for each ignition switch position.
    • If not the specified value, replace the ignition switch.
Resistance Test

Ignition Switch Position Terminals 2 and 4 Terminals 3 and 4 Terminals 4 and 5 Terminals 4 and 6 Terminals 5 and 6
Off Key Out Infinite Infinite Infinite Infinite Infinite
Off Key IN Infinite Infinite < 5.0 Ω Infinite Infinite
Accessory Infinite < 5.0 Ω Infinite Infinite Infinite
Run < 5.0 Ω < 5.0 Ω Infinite Infinite < 5.0 Ω
Start < 5.0 Ω Infinite Infinite Infinite 1275-1325 Ω