LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1572 (Wiring Systems And Power Management - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Delphi Connectors (Push To Seat) >> Terminal Repair

Terminal Repair

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Slip the cable seal away from the terminal.
  2. Cut the wire as close to the terminal as possible.
  3. Slip a new cable seal onto the wire.
  4. Strip 5 mm (3/16 in) of insulation from the wire.
  5. Crimp a new terminal to the wire.
  6. Solder the crimp with rosin core solder.
  7. Slide the cable seal toward the terminal.
  8. Crimp the cable seal and the insulation.
  9. If the connector is outside of the passenger compartment, apply grease to the connector.
scientia non olet · About LEMON Manuals