Terminal Removal

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Follow the steps below in order to repair push to seat connectors.

Remove the terminal position assurance (TPA) device, the connector position assurance (CPA) device, and/or the secondary lock.

Fig 1: View Of Connector Halves

Courtesy of GENERAL MOTORS CORP.

Separate the connector halves (1).

Fig 2: Identifying Removal Tool & Terminal

Courtesy of GENERAL MOTORS CORP.

Use the proper pick or removal tool (1) in order to release the terminal. See the release tool cross reference in the Reference Guide of the J-38125 to ensure that the correct release tool is used.
Gently pull the cable and the terminal (2) out of the back of the connector.

Fig 3: Identifying Locking Device

Courtesy of GENERAL MOTORS CORP.

Re-form the locking device if you are going to reuse the terminal (1).
To repair the terminal, refer to Terminal Repair below.