Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Turn the ignition switch to the OFF position.
Remove the driver knee bolster. Refer to Knee Bolster Replacement (With SLT) or Knee Bolster Replacement (Without SLT) .

Fig 1: Locating Pedal Position Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Disconnect the adjustable pedal position sensor jumper harness electrical connector (1).

Fig 2: Identifying Pedal Adjuster Position Sensors

Courtesy of GENERAL MOTORS CORP.

Remove the adjustable pedal position sensor bolts (1).

Fig 3: Identifying brake & accelerator Pedal Adjuster Position Sensor

Courtesy of GENERAL MOTORS CORP.

Remove the brake and accelerator pedal adjuster position sensor (1).