LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1566 (Automatic Transmission - 6L45/6L50/6L80/6L90 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Steering Cable Retainer On Steering Column
    GM1774414Courtesy of GENERAL MOTORS CORP.
    WARNING: The automatic transaxle range selector cable is made out of two cable sections. After initial connection never separate the two metal couplings from one another. Integrity of the connection of the two metal couplings will be lost if separation of the two metal couplings occurs. When servicing the transaxle remove the cable at the automatic transaxle range selector lever and at the automatic transaxle range selector cable bracket. If either section of the cable needs to be replaced, replace both of the cable sections. Loss of connection integrity of the two metal couplings can cause loss of transaxle shift control which could result in personal injury.
  1. Position the steering column shift lever to the park position.
  2. Remove the instrument panel knee bolster. Refer to Knee Bolster Replacement (With SLT) or Knee Bolster Replacement (Without SLT) .
  3. Remove the driver seat. Refer to Front Seat Replacement - Bucket .
  4. Pull back the carpet and insulation around the driver area.
  5. Remove the retainer securing the cable to the steering column.
    6. Fig 2: View Of Cable, Steering Column Ball Stud & Steering Column Bracket
    GM1774419Courtesy of GENERAL MOTORS CORP.
  6. Remove the cable end from the steering column ball stud.
  7. Depress the tangs and remove the cable from the steering column bracket.
    8. Fig 3: View Of Range Selector Cable
    GM1774421Courtesy of GENERAL MOTORS CORP.
    NOTE: Avoid unnecessary twisting/bending of the range selector cable when removing the cable from the support.
  8. Remove the range selector cable from the support.
    9. Fig 4: Cable Grommet & Floor Panel
    GM858974Courtesy of GENERAL MOTORS CORP.
  9. Remove the cable grommet from the floor panel.
  10. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
    11. Fig 5: Cable Clips & Floor Panel Reinforcement
    GM394470Courtesy of GENERAL MOTORS CORP.
  11. Remove the clips on the cable from the floor panel reinforcement.
  12. Ensure the transmission manual shaft is positioned in mechanical park.
  13. Remove the cable clip on the transfer case, if equipped.
    14. Fig 6: View Of Range Selector Cable & Cable Bracket Retainer
    GM1707190Courtesy of GENERAL MOTORS CORP.
  14. Remove the range selector cable (2) from the transmission range selector lever ball stud.
  15. Remove the retainer (1) that secures the cable to the bracket.
  16. Depress the tangs and remove the cable from the bracket.
  17. Remove the transmission range selector cable from the vehicle.
scientia non olet · About LEMON Manuals