Automatic Transmission Range Selector Lever Replacement

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Automatic Transmission Range Selector Lever

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Apply the park brake. Shift the transmission into neutral. Raise the vehicle. Refer to Lifting and Jacking the Vehicle . Disconnect the transmission range selector cable from the range selector cable lever ball stud.
1	Transmission Range Selector Cable Lever Nut WARNING: Hold the transmission range selector lever while removing or installing the lever retaining nut. Failure to hold the lever can cause damage to the transmission internal park system components which could allow the vehicle to roll when placed in the park position. CAUTION: Refer to Fastener Caution . Tighten: 25 N.m (18 lb ft)
2	Transmission Range Selector Cable Lever

Callout

Component Name

Preliminary Procedures

Apply the park brake.
Shift the transmission into neutral.
Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
Disconnect the transmission range selector cable from the range selector cable lever ball stud.

Transmission Range Selector Cable Lever Nut

WARNING: Hold the transmission range selector lever while removing or installing the lever retaining nut. Failure to hold the lever can cause damage to the transmission internal park system components which could allow the vehicle to roll when placed in the park position.

CAUTION: Refer to Fastener Caution .

Tighten: 25 N.m (18 lb ft)

Transmission Range Selector Cable Lever