LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1565 (Engine Control System & Fuel System - 4.8L, 5.3L, 6.0L, 6.2L - Repair Instructions) >> Repair Instructions >> Evaporative Emission System Hose/Pipe Replacement (25 Ext/Crew Cab With 26 gal Tank) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Small EVAP Rear Pipe Quick Connect Fittings
    GM1854510Courtesy of GENERAL MOTORS CORP.
  1. Position and connect the small EVAP rear pipe quick connect fittings to the rollover valve and the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service .
    2. Fig 2: Locating Fuel Tank Clips
    GM1854508Courtesy of GENERAL MOTORS CORP.
  2. Position and connect the EVAP rear pipe quick connect fittings to the rollover valve and the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Install the EVAP rear pipe to the fuel tank clips (1 and 2).
    4. Fig 3: Locating Fuel Tank Clip
    GM1854507Courtesy of GENERAL MOTORS CORP.
  4. Install the EVAP canister purge pipe to the fuel tank clip (1).
  5. Install the fuel tank. Refer to Fuel Tank Replacement (35 Reg/Ext/Crew Cab With 34 Gal Tank)  or Fuel Tank Replacement (15 Ext/Crew Cab With 26 Gal Tank)  or Fuel Tank Replacement (15/25 Reg/Ext/Crw Cab With 34 Gal Tnk)  or Fuel Tank Replacement (15 Rec Cab With 26 Gal Tank)  or Fuel Tank Replacement (25 Ext/Crew Cab With 26 Gal Tank) .
scientia non olet · About LEMON Manuals