LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1565 (Engine Control System & Fuel System - 4.8L, 5.3L, 6.0L, 6.2L - Repair Instructions) >> Repair Instructions >> Evaporative Emission System Cleaning >> EVAP Cleaning Procedure

EVAP Cleaning Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the EVAP canister. Refer to Evaporative Emission Canister Replacement (25 Ext/Crew Cab With 26 Gal Tank)  or Evaporative Emission Canister Replacement (15 Regular Cab)  or Evaporative Emission Canister Replacement (35 Reg/Ext/Crew Cab With 34 Gal Tank)  or Evaporative Emission Canister Replacement (15/25 Reg/Ext/Crw Cab With 34 Gal Tnk)  or Evaporative Emission Canister Replacement (15 Ext/Crew Cab) .
  2. Turn OFF the main valve on the J 41413-200  .
  3. Disconnect the hose from the diagnostic station pressure regulator.
  4. Using a section of vacuum hose, connect one end to the diagnostic station pressure regulator.
  5. Connect the other end of the vacuum hose to the canister side of the purge pipe.
  6. Turn ON the main nitrogen cylinder valve and continue to discharge nitrogen for 15 seconds.
  7. If the nitrogen does not dislodge the carbon particles, replace the purge pipe.
  8. Return the EVAP pressure/purge diagnostic station to the stations original condition.
  9. Install a new EVAP canister. Refer to Evaporative Emission Canister Replacement (25 Ext/Crew Cab With 26 Gal Tank)  or Evaporative Emission Canister Replacement (15 Regular Cab)  or Evaporative Emission Canister Replacement (35 Reg/Ext/Crew Cab With 34 Gal Tank)  or Evaporative Emission Canister Replacement (15/25 Reg/Ext/Crw Cab With 34 Gal Tnk)  or Evaporative Emission Canister Replacement (15 Ext/Crew Cab) .
  10. Connect all previously disconnected EVAP pipe connectors.
  11. Lower the vehicle.
  12. Continue with the published service manual diagnostic DTC procedure.
scientia non olet · About LEMON Manuals