LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1565 (Engine Control System & Fuel System - 4.8L, 5.3L, 6.0L, 6.2L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement (Rear of Tank) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Clean the evaporative emission (EVAP) connections and surrounding areas prior to disconnecting the fittings in order to avoid possible system contamination.
    Fig 1: Identifying Canister Vent Solenoid Hose & Canister Vent Solenoid
    GM2161074Courtesy of GENERAL MOTORS CORP.
  1. Lift and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Cut the canister vent solenoid hose (1) approximately 76 mm (3 in) from the evaporative emission canister vent solenoid (2).
    3. Fig 2: Identifying Canister Vent Solenoid Hose & Filter
    GM2161083Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the vent solenoid hose retainers (1).
  4. Remove the vent solenoid hose and filter (2).
  5. Replace the vent hose with bulk 5/8 in heater hose.
scientia non olet · About LEMON Manuals