Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying EVAP Vent Solenoid Hose, Filter, Connector & Strap

Courtesy of GENERAL MOTORS CORP.

Use a hose clamp (1) at the end of the vent hose.
Ensure the filter (3) points down.
Secure the vent hose with a tie strap (2) to the vent hose tee connector (4).
Use 5/8 in heater hose and secure it along the frame with tie straps as needed.

Fig 2: Identifying EVAP Vent Solenoid

Courtesy of GENERAL MOTORS CORP.

Position and install the evaporative canister vent solenoid (1) to the vehicle.
Use 5/8 in heater hose (2) to secure both ends with hose clamps (3).