LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1565 (Engine Control System & Fuel System - 4.8L, 5.3L, 6.0L, 6.2L - Repair Instructions) >> Repair Instructions >> Engine Control Module Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of ECM Components
    GM1703437Courtesy of GENERAL MOTORS CORP.
  1. Record the current Engine Oil Life percentage, and use a scan tool to update the NEW ECM, if replacing.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery) or Battery Negative Cable Disconnection and Connection (Dual Batteries) or Battery Negative Cable Disconnection and Connection (Auxiliary Battery) .
  3. Disengage the engine wiring harness upper electrical connector retainer (2) and remove the connector (1) from the ECM.
  4. Disengage the engine wiring harness lower electrical connector retainer (3) and remove the connector (4) from the ECM.
    5. Fig 2: View Of ECM & Bracket
    GM1703439Courtesy of GENERAL MOTORS CORP.
  5. Disengage the retainer tabs securing the ECM to the bracket.
  6. Remove the ECM.
scientia non olet · About LEMON Manuals