LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1565 (Engine Control System & Fuel System - 4.8L, 5.3L, 6.0L, 6.2L - Repair Instructions) >> Repair Instructions >> Camshaft Position Sensor Replacement (Except RPOs LY2, LY5, LH6 and LMG) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of CMP Sensor & O-Ring
    GM1658166Courtesy of GENERAL MOTORS CORP.
  1. Inspect the CMP O-ring seal for cuts or damage. If the seal is not cut or damaged, it may be used again.
  2. Lubricate the O-ring seal with clean engine oil.
  3. Install the O-ring seal (704) onto the sensor.
  4. Instal the CMP sensor (703) to the front cover.
    5. Fig 2: View Of CMP Sensor Wire Harness & Bolts
    GM1658163Courtesy of GENERAL MOTORS CORP.
  5. Install the CMP sensor wire harness (737).
  6. Connect the CMP sensor wire harness electrical connectors to the CMP sensor and the CMP actuator magnet.
    7. CAUTION: Refer to Fastener Caution .
  7. Install the 3 CMP sensor wire harness bolts (738).

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

    8. Fig 3: View Of Electrical Connector, Cable Channel Bolt & Pin
    GM1697734Courtesy of GENERAL MOTORS CORP.
  8. Connect the engine wiring harness electrical connector (1) to the CMP sensor wire harness.
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals