Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Clean the evaporative emission (EVAP) connections and surrounding areas prior to disconnecting the fittings in order to avoid possible system contamination.

Fig 1: Identifying Evaporative Emission Canister Vent Solenoid Valve

Courtesy of GENERAL MOTORS CORP.

Lift and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Cut the canister vent solenoid hose (1) approximately 76 mm (3 in) from the evaporative emission canister vent solenoid (2).

Fig 2: Identifying EVAP Solenoid Valve Retaining Tab

Courtesy of GENERAL MOTORS CORP.

Pull back on the retaining tab (1) and release the vent solenoid valve (2).

Fig 3: Identifying EVAP Vent Solenoid Hose

Courtesy of GENERAL MOTORS CORP.

Disconnect the vent solenoid hose from the plastic retainers (1).
Remove the vent solenoid hose.
Replace the vent hose with bulk 5/8 in heater hose.