Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of EVAP Canister Purge Solenoid Valve Tube Quick Connect Fitting

Courtesy of GENERAL MOTORS CORP.

Remove the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
Disconnect the evaporative emission (EVAP) canister purge solenoid valve tube quick connect fitting (1) from the EVAP purge solenoid valve. Refer to Plastic Collar Quick Connect Fitting Service .
Reposition the tube out of the way.

Fig 2: View Of Engine Wiring Harness & Components

Courtesy of GENERAL MOTORS CORP.

Disconnect the engine wiring harness electrical connector (1) from the EVAP purge valve solenoid.

Fig 3: View Of EVAP Canister Purge Solenoid Valve, Bolt & O-Ring Seal

Courtesy of GENERAL MOTORS CORP.

Remove the EVAP canister purge solenoid valve bolt (1).
Remove the EVAP canister purge solenoid valve (2) from the upper intake manifold.
Remove the EVAP canister purge solenoid valve O-ring seal (3) from the upper intake manifold, if necessary.