LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1563 (Engine Control System & Fuel System - 4.3L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Canister Purge Solenoid Valve, Bolt & O-Ring Seal
    GM1876613Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the EVAP canister purge solenoid valve O-ring seal with clean engine oil in order to aid with the installation.
  2. Install the EVAP canister purge solenoid valve (2) into the upper intake manifold.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the EVAP canister purge solenoid valve bolt (1).

    Tighten:  Tightne the bolt to 10 N.m (89 lb in).

    4. Fig 2: View Of Engine Wiring Harness & Components
    GM1876492Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector (1) to the EVAP purge valve solenoid.
    5. Fig 3: View Of EVAP Canister Purge Solenoid Valve Tube Quick Connect Fitting
    GM1876612Courtesy of GENERAL MOTORS CORP.
  5. Position the EVAP canister purge solenoid tube, and connect the tube quick connect fitting (1) to the EVAP purge solenoid valve. Refer to Plastic Collar Quick Connect Fitting Service .
  6. Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
scientia non olet · About LEMON Manuals