Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Turbocharger Vane Position Sensor & Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .

NOTE: Note the routing of the turbocharger vane position sensor pigtail prior to removal.

Disconnect the engine wiring harness electrical connector (1) from the turbocharger vane position sensor electrical connector (2).

Fig 2: View Of Turbocharger Vane Position Sensor & Electrical Connector Clips

Courtesy of GENERAL MOTORS CORP.

Remove the turbocharger vane position sensor electrical connector clips from the wiring harness bracket.
Remove the thermal reflective shield/tape from the vane position sensor, if required.
Remove the turbocharger vane position sensor from the turbocharger.