Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Turbocharger Vane Position Sensor & Electrical Connector Clips

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the turbocharger vane position sensor to the turbocharger.
Tighten: Tighten the sensor to 28 N.m (21 lb ft).
Install the turbocharger vane position sensor electrical connector clips to the wiring harness bracket.

Fig 2: Turbocharger Vane Position Sensor & Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the engine wiring harness electrical connector (1) to the turbocharger vane position sensor electrical connector (1).