Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Fuel Line Bracket & Nut

Courtesy of GENERAL MOTORS CORP.

Disconnect the fuel feed and return lines. Refer to Metal Collar Quick Connect Fitting Service .
Remove the fuel line bracket nut.
Remove the fuel line bracket from the stud.
Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .

Fig 2: Fuel Bundle Clips & Transmission Brackets

Courtesy of GENERAL MOTORS CORP.

Remove the fuel bundle clips (2) from the transmission brackets (1).
Disconnect the chassis harness from the retaining clips.
Remove the fuel system cooler, if necessary. Refer to Fuel Cooler Replacement (Pickup) or Fuel Cooler Replacement (Cab/Chassis) .

Fig 3: View Of Fuel Feed & Return Lines At Fuel Tank

Courtesy of GENERAL MOTORS CORP.

Disconnect the fuel feed and return lines from the fuel tank lines. Refer to Plastic Collar Quick Connect Fitting Service .

Fig 4: View Of Fuel Pipe Bundle (Cab/Chassis)

Courtesy of GENERAL MOTORS CORP.

Remove the fuel bundle nuts from the chassis.

Fig 5: View Of EBCM/EHCU Assembly

Courtesy of GENERAL MOTORS CORP.

Loosen the electronic brake control module (EBCM) bracket bolts (4).
Allow the EBCM to remain loose in order to allow fuel pipe clearance.
Remove the fuel bundle using the following procedure:
1. Guide the fuel bundle pipes towards the rear of vehicle to clear the engine.
2. Lower the fuel bundle while moving it foreword and out.