LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1560 (Engine Control System & Fuel System - 6.6L (LMM) - Repair Instructions) >> Repair Instructions >> Fuel Level Sensor Replacement (Cab/Chassis - Rear Tank) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Level Sensor Electrical Connector, Locking Tangs & Retaining Clip
    GM740113Courtesy of GENERAL MOTORS CORP.
  1. Remove the sending unit. Refer to Fuel Sender Assembly Replacement .
  2. Disconnect the fuel level sensor electrical connector (1).
  3. Remove the sensor retaining clip (3).
  4. Squeeze the locking tangs (2) and remove the fuel level sensor.
scientia non olet · About LEMON Manuals