LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1560 (Engine Control System & Fuel System - 6.6L (LMM) - Repair Instructions) >> Repair Instructions >> Fuel Cooler Replacement (Pickup) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel System Cooler (Pickup)
    GM737642Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the fuel lines at the cooler (1). Refer to Metal Collar Quick Connect Fitting Service .
  3. Remove the fuel cooler bolts (4, 6).
  4. Remove the fuel cooler (1).
  5. Remove the fuel cooler support bracket bolt (2, 5), and bracket (3) from the fuel cooler (1), if necessary.
scientia non olet · About LEMON Manuals