LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1560 (Engine Control System & Fuel System - 6.6L (LMM) - Repair Instructions) >> Repair Instructions >> Exhaust Gas Recirculation Valve Motor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: There is no gasket between the motor and the valve. However, some vehicles may have a thin metal spacer between the motor and the valve that appears to be a gasket. This spacer is used to correct for production variances in some valves and should be reinstalled with the new motor.
    Fig 1: Engine Wiring Harness Electrical Connector
    GM1871112Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  2. Disconnect the engine wiring harness electrical connector (1) from the exhaust gas recirculation (EGR) valve motor.
    3. Fig 2: EGR Valve Motor
    GM1873223Courtesy of GENERAL MOTORS CORP.
  3. Remove the EGR valve motor screws.
  4. Remove the EGR valve motor, and spacer (if equipped) from the EGR valve.
scientia non olet · About LEMON Manuals