LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1559 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Rear Door Opening Weatherstrip Replacement (Crew Cab) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Pinch-Weld Flange Weatherstrip (Rear Door Opening)
    GM686586Courtesy of GENERAL MOTORS CORP.
  1. Align the weatherstrip to the door opening with the 2 dots positioned on the upper right and left side.
  2. Align the weatherstrip to the door opening with the bond joint positioned at the lower center of the door opening.
  3. Install the weatherstrip to the pinch-weld flange. Ensure that the weatherstrip is fully seated.
  4. Install the rear door sill plate. Refer to Rear Side Door Sill Trim Plate Replacement (Crew Cab) or Rear Side Door Sill Trim Plate Replacement (Extended Cab) .
scientia non olet · About LEMON Manuals