LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1559 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Front Door Opening Weatherstrip Replacement (Extended Cab) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Weatherstrip & Pinch-Weld Flange
    GM1673255Courtesy of GENERAL MOTORS CORP.
  1. Align the weatherstrip to the door opening with the 2 dots positioned on the upper right and left side.
  2. Install the weatherstrip (1) to the pinch-weld flange (2). Ensure that the weatherstrip is fully seated around the door opening.
  3. Install the windshield pillar molding. Refer to Windshield Pillar Garnish Molding Replacement .
  4. Install the body lock pillar trim. Refer to Body Lock Pillar Trim Replacement (Crew Cab) or Body Lock Pillar Trim Replacement (Extended Cab) or Body Lock Pillar Trim Replacement (Regular Cab) .
  5. Install the hinge pillar trim. Refer to Body Hinge Pillar Trim Panel Replacement .
  6. Install the sill plate. Refer to Front Side Door Sill Trim Plate Replacement (Extended Cab) or Front Side Door Sill Trim Plate Replacement (Regular Cab/Crew Cab) or Rear Side Door Sill Trim Plate Replacement (Crew Cab) or Rear Side Door Sill Trim Plate Replacement (Extended Cab) .
  7. Inspect the door closing effort and seal to door fit.
scientia non olet · About LEMON Manuals