Windshield Side Reveal Molding Replacement

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Window Side Reveal Molding

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Open the front door on the side the reveal molding is being serviced. Pull the door auxiliary weatherstrip up to the roof header. Remove the air inlet grille panel end cap.
1	Reveal Molding Nut
2	Windshield Side Reveal Molding Tip: Upon installation, tuck the bottom edge of the reveal molding under the end cap of the air inlet grille panel prior to the screw installation.
3	Windshield Side Reveal Molding Screw (Qty: 5) CAUTION: Refer to Fastener Caution . Tighten: 2 N.m (18 lb in)