Front Side Door Window Regulator Replacement (Power)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Side Door Window Regulator (Power)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Position the door window as needed for service. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement (SLT, A95) or Front Side Door Trim Panel Replacement (Except YE9 or SLT) . Remove the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
1	Front Side Door Window Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Procedure Tape the window to the door frame to prevent it from moving. Loosen the 2 bolts that attach the window to the window regulator. Disconnect the electrical connector. Tighten: 9 N.m (80 lb in)
2	Front Side Door Window Regulator Bolt (Qty: 3) Tighten: 9 N.m (80 lb in)
3	Front Side Door Window Regulator Nut (Qty: 2) Tighten: 9 N.m (80 lb in)
4	Front Side Door Window Regulator