Front Side Door Window Rear Channel Replacement

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Side Door Window Rear Channel

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Position the door window as needed for service. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement (SLT, A95) or Front Side Door Trim Panel Replacement (Except YE9 or SLT) . Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
1	Front Door Window Run Channel Rear Bolt CAUTION: Refer to Fastener Caution . Tighten: 10 N.m (89 lb in)
2	Front Door Window Rear Run Channel Tip: Raise the door window to the fully close position to gain access the run channel.

Callout

Component Name

Preliminary Procedures

Position the door window as needed for service.
Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement (SLT, A95) or Front Side Door Trim Panel Replacement (Except YE9 or SLT) .
Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .

Front Door Window Run Channel Rear Bolt

CAUTION: Refer to Fastener Caution .

Tighten: 10 N.m (89 lb in)

Front Door Window Rear Run Channel
Tip: Raise the door window to the fully close position to gain access the run channel.