Rear Side Door Inside Handle Replacement (without SLT)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Side Door Inside Handle (Without SLT)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Front Side Door Inside Handle Seal Procedure Rotate the front side door inside release handle to full open position. Use a small pair of 45 degree needle nose pliers to remove the foam seal at the handle to expose retaining clip. Use a small pair of 45 degree needle nose pliers to release the clip inside the handle. Remove the pin after the clip is released.
2	Front Side Door Inside Handle

Callout

Component Name

Front Side Door Inside Handle Seal

Procedure

Rotate the front side door inside release handle to full open position.
Use a small pair of 45 degree needle nose pliers to remove the foam seal at the handle to expose retaining clip.
Use a small pair of 45 degree needle nose pliers to release the clip inside the handle.
Remove the pin after the clip is released.

Front Side Door Inside Handle