LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1557 (Door Lock System & Door Handles) >> Repair Instructions >> Front Side Door Inside Handle Replacement (with SLT) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove door upper trim panel. Refer to Upper Extension Trim Panel Replacement .
    2. Fig 1: Door Trim Panel
    GM2374589Courtesy of GENERAL MOTORS CORP.
  2. Pull the door trim panel away from the door and support the bottom of the trim panel on the door panel hooks. Refer to Front Side Door Trim Panel Replacement (SLT, A95) or Front Side Door Trim Panel Replacement (Except YE9 or SLT) .
    3. Fig 2: View Of Front Side Door Inside Handle Assembly & Bolts
    GM1693916Courtesy of GENERAL MOTORS CORP.
  3. Remove the front side door inside handle fasteners (1).
  4. Remove the front side door inside handle assembly (2).
    1. Disconnect the electrical connector.
    2. If replacing the door handle, transfer the heated seat switch or seat adjuster memory switch, if equipped. Refer to Front Seat Heater Switch Replacement or Driver Seat Adjuster Memory Switch Replacement (Crew Cab) .
    3. Depress both tabs to remove the front side door cable and pull the cable rearward out of the handle assembly.
scientia non olet · About LEMON Manuals