LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1557 (Door Lock System & Door Handles) >> Repair Instructions >> Door Striker Replacement (Crew Cab) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If both of the door striker bolts are removed at the same time, the striker backing plate will fall into the body. This will result in additional time to perform the repair.
    Fig 1: View Of Door Striker & Bolts (Crew Cab)
    GM1673308Courtesy of GENERAL MOTORS CORP.
  1. Remove the lower striker bolt.
  2. Loosen the upper striker bolt enough in order to rotate the striker and the spacer, if equipped, away from the lower bolt hole.
  3. Install the lower striker bolt. Tighten the lower striker bolt sufficiently in order to hold the striker backing plate in place.
  4. Remove the upper striker bolt (1).
  5. Remove the spacer, if equipped.
  6. Remove the striker (2).
scientia non olet · About LEMON Manuals