LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1557 (Door Lock System & Door Handles) >> Diagnostic Information and Procedures >> Power Door Locks Malfunction (RPO AN3/DL3) >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the appropriate door latch.
  2. Install a 15A fused jumper wire between one of the control terminals and 12V. Momentarily install a jumper wire between the other control terminal and ground. Reverse the jumper wires at least two times, the door latch should perform the LOCK/ UNLOCK functions.
    • If it does not perform as specified, replace the door latch.
scientia non olet · About LEMON Manuals