Component Testing
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the driver door latch.
- Test for infinite resistance between the signal terminal 9 and the low reference terminal 8 with the switch in the open position.
- If not the specified value, replace the driver door latch.
- Test for less than 2 ohms between the signal terminal 9 and the low reference terminal 8 with the switch in the Unlock position.
- If greater than the specified range, replace the driver door latch.