LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1555 (Battery, Charging System And Starting System - Non-Hybrid) >> Repair Instructions >> Starter Solenoid Cable Replacement (Gas without Auxiliary Battery) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Battery Connections
    GM2352427Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery)  or Battery Negative Cable Disconnection and Connection (Dual Batteries)  or Battery Negative Cable Disconnection and Connection (Auxiliary Battery) .
  2. Remove the right side front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Right Side (Chevrolet) or Front Wheelhouse Liner Replacement - Right Side (GMC) .
  3. Open the starter solenoid cable positive battery post cover.
  4. Loosen the battery post clamp nut (1).
  5. Remove the mega-fuse holder nut (2) and detach the battery positive cable terminal (3)
  6. Remove the starter solenoid cable (4) from the battery.
    7. Fig 2: Starter Solenoid Cable Components
    GM2352428Courtesy of GENERAL MOTORS CORP.
  7. Remove the starter solenoid cable retainer bolt (1) frome the right frame rail.
  8. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
    9. Fig 3: Starter Solenoid Nut & Starter Cable Terminal
    GM2352429Courtesy of GENERAL MOTORS CORP.
  9. Remove the starter solenoid nut (1) and the starter cable terminal (2), from the vehicle.
scientia non olet · About LEMON Manuals