Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Starter Solenoid Nut & Starter Cable Terminal

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the starter cable terminal (2) and nut (1), to the starter.Tighten the nut to 9 N.m (80 lb in)

Fig 2: Starter Solenoid Cable Components

Courtesy of GENERAL MOTORS CORP.

Install the starter solenoid cable retaining clip (2) and nut (1), to the right frame rail.Tighten the bolt to 25 N.m (18 lb ft)

Fig 3: Battery Connections

Courtesy of GENERAL MOTORS CORP.

Install the starter solenoid cable to the battery post and tighten the nut (1) to 9 N.m (80 lb in)
Install the battery positive terminal (3) to the mega-fuse holder and tighten nut (2) to 9 N.m (80 lb in)
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery) or Battery Negative Cable Disconnection and Connection (Dual Batteries) or Battery Negative Cable Disconnection and Connection (Auxiliary Battery) .