LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1555 (Battery, Charging System And Starting System - Non-Hybrid) >> Repair Instructions >> Generator Replacement (6.6L) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Generator & Bolts
    GM1874246Courtesy of GENERAL MOTORS CORP.
  1. Install the generator.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the generator bolts (1).

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    3. Fig 2: View Of Engine Wiring Harness Electrical Connector & Generator
    GM1874242Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness electrical connector (1) to the generator (2).
    4. Fig 3: View Of Engine Wiring Harness Terminal, Boot & Nut
    GM1874244Courtesy of GENERAL MOTORS CORP.
  4. Install the engine wiring harness terminal (3) to the generator.
  5. Install the engine wiring harness nut (1).

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

  6. Position the engine wiring harness boot (2) in order to cover the terminal stud.
  7. Install the drive belt. Refer to Drive Belt Replacement .
  8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery)  or Battery Negative Cable Disconnection and Connection (Dual Batteries)  or Battery Negative Cable Disconnection and Connection (Auxiliary Battery) .
scientia non olet · About LEMON Manuals