LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1555 (Battery, Charging System And Starting System - Non-Hybrid) >> Repair Instructions >> Generator Bracket Replacement (V6) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Generator, Bracket & Bolts
    GM1877553Courtesy of GENERAL MOTORS CORP.
  1. Install the generator bracket onto the stud.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the generator bracket bolts and nut.

    Tighten:  Tighten the bolts/nut to 41 N.m (30 lb ft).

  3. Install the drive belt idler pulley. Refer to Drive Belt Idler Pulley Replacement - Right Side .
  4. Install the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .
  5. Install the generator. Refer to Generator Replacement (V6)  or Generator Replacement (V8)  or Generator Replacement (6.6L) .
scientia non olet · About LEMON Manuals