Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Generator Battery Jumper Cable

Courtesy of GENERAL MOTORS CORP.

Install the generator battery jumper cable to the vehicle.

Fig 2: View Of Generator Battery Jumper Cable & Components

Courtesy of GENERAL MOTORS CORP.

Install the generator battery jumper cable terminal (4) to the mega fuse stud.

CAUTION: Refer to Fastener Caution .

Install the generator battery jumper cable to mega fuse nut (3) and tighten to 9 N.m (80 lb in).
Install the generator battery jumper cable clip (2) to A/C evaporator tube.
Install the generator battery jumper cable clip (1) to the stud.

Fig 3: View Of Mega Fuse Cover

Courtesy of GENERAL MOTORS CORP.

Install the mega fuse cover.

Fig 4: View Of Battery Jumper Cable Terminal, Nut & Bolt

Courtesy of GENERAL MOTORS CORP.

Install the generator battery jumper cable terminal (1) to the generator stud.
Install the generator battery jumper cable nut (2) to the generator and tighten to 9 N.m (80 lb in).
Position the generator battery jumper cable boot (3).
Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
Install the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery) or Battery Negative Cable Disconnection and Connection (Dual Batteries) or Battery Negative Cable Disconnection and Connection (Auxiliary Battery) .