LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1555 (Battery, Charging System And Starting System - Non-Hybrid) >> Repair Instructions >> Battery Positive Cable Replacement (Diesel) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Under Hood Junction Block Cover
    GM1702793Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery)  or Battery Negative Cable Disconnection and Connection (Dual Batteries)  or Battery Negative Cable Disconnection and Connection (Auxiliary Battery) .
  2. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  3. Remove the underhood junction block cover.
    4. Fig 2: View Of Junction Block & Retainers
    GM1702795Courtesy of GENERAL MOTORS CORP.
  4. Lift the junction block retainers from the locked position (3) and rotate the retainers to the open position (1).
  5. Reposition the junction block.
    6. Fig 3: View Of Positive Battery Cable Connector & Underhood Bussed Electrical Center
    GM1702797Courtesy of GENERAL MOTORS CORP.
  6. Remove the positive battery cable connector (1) from the underhood bussed electrical center (UBEC).
    7. Fig 4: View Of Positive Battery Cable
    GM1873915Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the positive battery cable (1) from the glow plug control module.
    8. Fig 5: View Of Mega Fuse Cover
    GM1873916Courtesy of GENERAL MOTORS CORP.
  8. Remove the mega fuse cover.
    9. Fig 6: View Of Mega Fuse Nuts
    GM1873917Courtesy of GENERAL MOTORS CORP.
  9. Remove the positive battery cable to mega fuse nuts (1).
  10. Remove the positive battery cable terminals from the mega fuse studs.
    11. Fig 7: View Of Positive Battery Cable Clip & Nuts
    GM1873918Courtesy of GENERAL MOTORS CORP.
  11. Remove the positive battery cable clip nuts (2) from the studs on the plenum front panel.
  12. Remove the positive battery cable clip (1) from the stud on the plenum front panel.
    13. Fig 8: View Of Positive Battery Cable Clips
    GM1873919Courtesy of GENERAL MOTORS CORP.
  13. Remove the positive battery cable clips (1) from the studs on the plenum front panel.
  14. Remove the positive battery cable from the vehicle.
scientia non olet · About LEMON Manuals