LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1555 (Battery, Charging System And Starting System - Non-Hybrid) >> Repair Instructions >> Battery Negative Cable Replacement (Diesel) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Negative Battery Cable, Clip, Wiring Harness Ground & Bolt
    GM1873887Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery)  or Battery Negative Cable Disconnection and Connection (Dual Batteries)  or Battery Negative Cable Disconnection and Connection (Auxiliary Battery) .
  2. Remove the negative battery cable clip (1) from the positive and negative cable bracket.
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Remove the engine wiring harness ground bolt (3).
  5. Reposition the engine wiring harness ground (4) and remove the negative battery cable (2) from the engine block.
    6. Fig 2: View Of Negative Battery Cable
    GM1873888Courtesy of GENERAL MOTORS CORP.
  6. Lower the vehicle.
  7. Remove the negative battery cable from the vehicle.
scientia non olet · About LEMON Manuals