Installation Procedure
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the auxiliary battery positive cable to the vehicle.
- Install the auxiliary battery positive cable terminal to the relay stud.
- Install the auxiliary battery positive cable nut (6) to the rely stud and tighten to 7.5 N.m (66 lb in).
- Position the auxiliary battery positive cable boot (5) at the auxiliary battery relay.
- Install the auxiliary battery positive cable to the battery positive post.
- Tighten the auxiliary battery positive cable nut (2) and tighten to 7.5 N.m (66 lb in).
- Install the auxiliary battery positive cable terminal to the underhood junction block stud.
- Install the auxiliary battery positive cable nut (1) to the underhood junction block stud and tighten to 5 N.m (44 lb in).
- Install the auxiliary battery positive cable clips (4) to the engine wiring harness.
- Close the auxiliary battery positive cable post cover.
- Install the underhood junction block cover.
- Connect the auxiliary battery. Refer to Battery Negative Cable Disconnection and Connection (Single Battery) or Battery Negative Cable Disconnection and Connection (Dual Batteries) or Battery Negative Cable Disconnection and Connection (Auxiliary Battery) .
CAUTION:
Refer to Fastener Caution
.