LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1555 (Battery, Charging System And Starting System - Non-Hybrid) >> Diagnostic Information and Procedures >> DTC P0621 (Diesel) >> Circuit/System Testing - Single Generator (w/o K76)

Circuit/System Testing - Single Generator (w/o K76)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X1 harness connector at the generator.
  2. Ignition ON, test for less than 1 V between the signal circuit terminal 1 and ground.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  3. Engine running, test for greater than 3.5 V between the signal circuit terminal 1 and ground.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
  4. If the circuit tests normal, test or replace the generator.
scientia non olet · About LEMON Manuals