Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Steering Column Shaft Assembly Components

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Use a NEW steering shaft lock plate retaining ring.

Install the following parts onto the steering shaft:
1. Lubricate the turn signal switch cancel cam (3) with GM P/N 12377900 (Canadian P/N 10953529).
2. Turn signal switch cancel cam position plate (2)
3. Steering shaft lock plate retaining ring (1) using compressor J 23653-SIR and adapter J 42137 . See Special Tools .
Install the inflatable restraint steering wheel module coil and the inflatable restraint steering wheel module coil wave washer. Refer to Steering Wheel Inflatable Restraint Module Coil Replacement .