LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1552 (Steering Wheel And Steering Column) >> Repair Instructions >> Steering Shaft Upper Bearing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Refer to SIR Warning .
  1. Remove the steering column. Refer to Steering Column Replacement (Without HP2)  or Steering Column Replacement (HP2) .
  2. Remove the inflatable restraint steering wheel module coil. Refer to Steering Wheel Inflatable Restraint Module Coil Replacement .
  3. Remove the turn signal multifunction switch. Refer to Turn Signal Multifunction Switch Replacement .
  4. Remove the ignition lock cylinder case. Refer to Ignition Lock Cylinder Case Replacement .
  5. Remove the tilt spring. Refer to Steering Column Tilt Spring Replacement .
  6. Remove the automatic transmission control. Refer to Transmission Control Replacement .
    7. Fig 1: Steering Shaft Lock Plate Retaining Ring
    GM338052Courtesy of GENERAL MOTORS CORP.
  7. Using compressor J 23653-SIR  and adapter J 42137  , remove and discard the steering shaft lock plate retaining ring. See Special Tools .
    8. Fig 2: Identifying Steering Column Shaft Assembly Components
    GM664265Courtesy of GENERAL MOTORS CORP.
  8. Remove the following parts from the steering column shaft assembly:
    1. The turn signal switch cancel cam position plate (5)
    2. The turn signal switch cancel cam (4)
    3. The steering shaft upper bearing spring (3)
    4. The steering shaft upper bearing inner race seat (2)
    5. The steering shaft upper bearing inner race (1)
    9. Fig 3: Identifying Pivot Pins
    GM306307Courtesy of GENERAL MOTORS CORP.
  9. Remove the 2 pivot pins (3) from the steering column tilt head assembly (1) by using remover J 21854-01  (2). See Special Tools .
    10. Fig 4: View Of Steering Column Tilt Head Assembly & Steering Column
    GM1730627Courtesy of GENERAL MOTORS CORP.
  10. Install the tilt lever into the steering column tilt head assembly (1).
  11. Pull back on the tilt lever and at the same time, pull the steering column tilt head assembly (1) down and away from the steering column.
  12. Remove the steering column tilt head assembly.
  13. Remove anti-rotation pin J 42640  .
  14. Remove the tilt lever.
    15. Fig 5: View Of Upper Bearing Assembly
    GM1562300Courtesy of GENERAL MOTORS CORP.
  15. Remove the steering shaft upper bearing from the steering column tilt head assembly.
scientia non olet · About LEMON Manuals