LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1552 (Steering Wheel And Steering Column) >> Repair Instructions >> Steering Shaft Coupling Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Refer to SIR Warning .
CAUTION: With wheels of the vehicle facing straight ahead, secure the steering wheel utilizing steering column anti-rotation pin, steering column lock, or a strap to prevent rotation. Locking of the steering column will prevent damage and a possible malfunction of the SIR system. The steering wheel must be secured in position before disconnecting the following components:
  • The steering column
  • The intermediate shaft(s)
  • The steering gear

After disconnecting these components, do not rotate the steering wheel or move the front tires and wheels. Failure to follow this procedure may cause the SIR coil assembly to become un-centered and cause possible damage to the SIR coil. If you think the SIR coil has became un-centered, refer to your specific SIR coil's centering procedure to re-center SIR Coil.
  1. Ensure the front wheels are in the straight-ahead position.
    2. Fig 1: Locking Steering Column
    GM333146Courtesy of GENERAL MOTORS CORP.
  2. Install the J-42640:  pin in the steering column lower access hole.
  3. Remove the engine shield. Refer to Engine Shield Replacement .
  4. Use paint in order to mark the relationship of the upper intermediate steering shaft to the steering shaft coupling.
  5. Use paint in order to mark the relationship of the steering shaft coupling to the steering gear.
    6. Fig 2: Steering Shaft Coupling
    GM2410881Courtesy of GENERAL MOTORS CORP.
    NOTE: DO NOT pull on the steering shaft coupling (1) in order to separate the coupling from the steering gear.
  6. Remove the steering shaft coupling bolt (2) at the steering gear.
    7. Fig 3: View Of Upper & Lower Intermediate Shafts & Components
    GM1701888Courtesy of GENERAL MOTORS CORP.
  7. Remove the steering shaft coupling nut (1) and the bolt (2) at the upper intermediate steering shaft.
  8. Remove the steering shaft coupling from the vehicle.
scientia non olet · About LEMON Manuals